Fujitsu PRIMERGY RX300 S7 - Upgrading PSU from 450 W to 800 W; Required Tools; Preliminary Steps

126 Upgrade and Maintenance Manual RX300 S7
Power supply
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107
6.4 Upgrading PSU from 450 W to 800 W
Basic information
V CAUTION!
No mixed PSU configuration is allowed.
6.4.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the power supply unit: tool-less
6.4.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê In non-redundant PSU configurations, shut down the server as described in
section "Shutting down the server" on page 65.
Ê "Disconnecting power cords" on page 66
Customer Replaceable Units (CRU)
Average task duration: 5 minutes