RX300 S7
Upgrade and Maintenance Manual 501
Conversion configurations
15.2 Basic Procedures
15.2.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Converting the server model:
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver
15.2.2 Preliminary steps
Perform the following procedures:
Ê "Opening the rack door" on page 64
Ê "Disabling BitLocker functionality" on page 85.
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê Remove all external cables.
Ê "Removing the server cover" on page 72.
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
15.2.3 Removing the front cover
I The Removing of the front cover for all versions is to proceed in the same
way.
To Next Page
Loading...
