Fujitsu PRIMERGY RX300 S7 - Preparing the SAS RAID Controller; Installing the SAS RAID Controller

204 Upgrade and Maintenance Manual RX300 S7
Expansion cards and backup units
9.3.1.3 Preparing the SAS RAID controller
Figure 87: Installing the RAID card holder
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws (2).
9.3.1.4 Installing the SAS RAID controller
Ê Remove the SAS RAID controller from its protective packaging.
I For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section "Preparing the SAS RAID controller" on page 204.