424 Upgrade and Maintenance Manual
RX300 S7
Front panel
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107
13.2.3 Replacing the front VGA connector
13.2.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing the front VGA connector:
– Socket screw driver (5 mm)
13.2.3.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Field Replaceable Units (FRU)
Average task duration: 15 minutes
To Next Page
Loading...
