324 Upgrade and Maintenance Manual
RX300 S7
Processors
11.5 Handling processor heat sinks
11.5.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Installing or removing the processor heat sink:
– Phillips PH2 / (+) No. 2 screw driver
11.5.2 Preliminary steps
Perform the following procedures:
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Field Replaceable Units (FRU)
Average task duration: 15 minutes
To Next Page
Loading...
