Fujitsu PRIMERGY RX300 S7 - Removing the Front Panel Module; Removing the Front VGA Connector; Installing the New Front VGA Connector; Re-Installing the Front Panel Module

RX300 S7 Upgrade and Maintenance Manual 425
Front panel
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
13.2.3.3 Removing the front panel module
Ê "Removing the front panel module" on page 418
13.2.3.4 Removing the front VGA connector
Ê "Removing the front VGA connector" on page 423.
13.2.3.5 Installing the new front VGA connector
Ê Install the new front VGA connector as described in section "Installing the
front VGA connector" on page 419.
13.2.3.6 Re-installing the front panel module
Ê "Installing the front panel module" on page 413.
13.2.3.7 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107