Fujitsu PRIMERGY RX300 S7 - Removing the Optical Disc Drive (ODD); Required Tools; Preliminary Steps

RX300 S7 Upgrade and Maintenance Manual 351
Accessible drives
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107
12.6 Removing the optical disc drive (ODD)
12.6.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing the ODD: tool-less
12.6.2 Preliminary steps
Perform the following procedures:
Ê Ask the system administrator to eject all remaining backup or optical media
from the backup or optical disk drive before removing it from the server.
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Upgrade and Repair Units (URU)
Average task duration: 10 minutes