Fujitsu PRIMERGY RX300 S7 - Connecting Cables to the Expansion Card; Connecting a Backup Unit to the Expansion Card

RX300 S7 Upgrade and Maintenance Manual 205
Expansion cards and backup units
Figure 88: Installing the SAS RAID controller
Ê Carefully insert the RAID controller into PCI slot 7 and press down firmly until
it is fully seated in the slot (1).
I For slot preferences, please refer to section "Basic information" on
page 187.
Ê Secure the RAID controller with the screw on the RAID card holder (2).
9.3.1.5 Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I For a complete cabling overview, please refer to section "Cables
overview" on page 525.
9.3.1.6 Connecting a backup unit to the expansion card
Ê If applicable, connect a BBU or FBU to the expansion card as described in
sections "Installing a BBU" on page 227 or "Installing an FBU" on page 241.