RX300 S7
Upgrade and Maintenance Manual 383
Accessible drives
Ê "Verifying and configuring the backup software solution" on page 98
Ê "Enabling BitLocker functionality" on page 107
12.13 Replacing the RDX/DAT drive in 2.5-inch
version
12.13.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing accessible drive:
– Phillips PH2 / (+) No. 2 screw driver
12.13.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Removing backup and optical disk media" on page 89
Ê "Verifying and configuring the backup software solution" on page 89
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
