RX300 S7
Upgrade and Maintenance Manual 487
System board and components
14.4.3.3 Replacing the onboard SAS enabling key
Ê Remove the defective onboard SAS enabling key as described in section
"Removing onboard SAS enabling key" on page 485.
Ê Install the new onboard SAS enabling key as described in section "Installing
the onboard SAS enabling key" on page 483.
14.4.3.4 Concluding steps
Perform the following procedures to complete the task:
Ê "Installing the air duct" on page 74.
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Enabling BitLocker functionality" on page 107
14.5 Replacing the system board
Note on TPM
I The system board can be equipped with an optional TPM (Trusted
Platform Module). This module enables third party programs to store key
information (e. g. drive encryption using Windows Bitlocker Drive
Encryption).
Field Replaceable Units (FRU)
Average hardware task duration: 50 minutes
Average software task duration: 10 minutes
To Next Page
Loading...
