RX300 S7
Upgrade and Maintenance Manual 345
Accessible drives
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
12.4.3 Removing the defective LSD module
Ê "Removing the LSD module" on page 342
12.4.4 Installing the new LSD module
Ê "Installing a LSD module" on page 339
12.4.5 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107
To Next Page
Loading...
