Fujitsu PRIMERGY RX300 S7 - Removing a Memory Module; Installing a Memory Module; Concluding Steps

288 Upgrade and Maintenance Manual RX300 S7
Main memory
10.4.3 Removing a memory module
Ê Identify the defective memory slot using the server management software.
Ê Remove the defective memory module as described in section "Removing
memory modules" on page 284.
10.4.4 Installing a memory module
Ê Replace the defective memory module as described in section "Installing
memory modules" on page 280.
10.4.5 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Updating or recovering the system board BIOS and iRMC" on page 92
Ê "Enabling SVOM boot watchdog functionality" on page 101
Ê "Enabling replaced components in the system BIOS" on page 101
Ê "Verifying the memory mode" on page 102
Ê "Enabling BitLocker functionality" on page 107