Fujitsu PRIMERGY RX300 S7 - Connecting the RDX;DAT Drive to the USB 3.0 Interface Card

376 Upgrade and Maintenance Manual RX300 S7
Accessible drives
Ê Connect the USB cable to the connector USB INT1 on the system board.
Ê Route the cables as shown.
12.11.5.2 Connecting the RDX/DAT drive to the USB 3.0 interface card
Figure 222: Connecting the cables to the RDX/DAT drive
Ê Fasten the drive cage with the screw.
Ê Connecting the power cable C5 to the RDX/DAT drive (1).
Ê Connecting the USB cable C17 to the RDX/DAT drive (2).
Ê Route the cable C17 as shown in the two cable clamps (3) and behind the
SAS RAID controller (4).