Fujitsu PRIMERGY RX300 S7 - Installing the System Board; Mounting the System Board

RX300 S7 Upgrade and Maintenance Manual 493
System board and components
Ê Slightly lift up the system board by the memory module ejectors and a PCI
slot (1) in order to detach it from the centering bolts (C).
Ê Carefully shift the system board towards the server front until the plug shells
disengage from the cut-outs in the connector panel.
Ê Hold the defective system board by the memory module ejectors and a PCI
slot and at a slight angle lift it out of the chassis.
Ê "Removing the TPM board" on page 477
Ê Remove the UFM spacer from the systemboard
14.5.4 Installing the system board
14.5.4.1 Mounting the system board
Figure 309: Installing the system board
Ê Hold the new system board by the memory module ejectors and a PCI slot.
V CAUTION!
– Do not lift or handle the system board by any of its heat sinks!