RX300 S7
Upgrade and Maintenance Manual 199
Expansion cards and backup units
Ê "Enabling BitLocker functionality" on page 107
Ê "Closing the rack door" on page 84
9.2.3 Replacing expansion cards
Note on network settings recovery
I When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.2.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing expansion cards:
– Phillips PH2 / (+) No. 2 screw driver
●
Mounting slot brackets:
– Phillips PH2 / (+) No. 2 screw driver
9.2.3.2 Preliminary steps
Perform the following procedures:
Ê If applicable, ensure to note down your current network settings in the
operating system. For further information, please refer to section "Note on
network settings recovery" on page 199.
Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
