Fujitsu PRIMERGY RX300 S7 - Removing the SAS RAID Controller; Concluding Steps

208 Upgrade and Maintenance Manual RX300 S7
Expansion cards and backup units
9.3.2.3 Removing the SAS RAID controller
Figure 89: Removing the SAS RAID controller
Ê Loosen the screw on the RAID card holder (2).
Ê Carefully pull up on the SAS RAID controller in a vertical motion and remove
it from its slot (1).
9.3.2.4 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80