RX300 S7
Upgrade and Maintenance Manual 209
Expansion cards and backup units
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 97.
Ê "Enabling SVOM boot watchdog functionality" on page 101
Ê "Enabling BitLocker functionality" on page 107
Ê "Updating RAID controller firmware" on page 96
To Next Page
Loading...
