Fujitsu PRIMERGY RX300 S7 - Required Tools

RX300 S7 Upgrade and Maintenance Manual 489
System board and components
Note on network settings recovery
I When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
14.5.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the system board:
– Phillips PH2 / (+) No. 2 screw driver
● Replacing the system board:
– Magnifying glass for inspecting CPU socket springs (recommended)
If a TPM module is installed:
– Bit screw driver
– TPM bit insert
(
*
)
– thin slotted screw driver ( 2 x 0.4 mm)
(
*
)
(
*
)
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)