Fujitsu PRIMERGY RX300 S7 - Concluding Steps; Replacing a LSD Module; Required Tools; Preliminary Steps

344 Upgrade and Maintenance Manual RX300 S7
Accessible drives
12.3.4 Concluding steps
Perform the following procedures:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê "Enabling BitLocker functionality" on page 107
12.4 Replacing a LSD module
12.4.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing the LSD: tool-less
12.4.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Upgrade and Repair Units (URU)
Average task duration: 10 minutes