RX300 S7
Upgrade and Maintenance Manual 65
Basic hardware procedures
4.3 Shutting down the server
V CAUTION!
For further safety information, please refer to chapter "Important
information" on page 43.
I This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section "Verifying and
configuring the backup software solution" on page 89.
Ê In case of Multipath I/O environments, please refer to section "Note on
server maintenance in a Multipath I/O environment" on page 90.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 89.
Figure 8: Power button on the front panel
To Next Page
Loading...
