Fujitsu PRIMERGY RX300 S7 - Removing a Processor; Opening the Cover Plate

RX300 S7 Upgrade and Maintenance Manual 303
Processors
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê "Removing processor heat sinks" on page 329
11.3.3 Removing a processor
I This description applies to the following procedures:
– Removing CPU 2 from a dual-processor configuration
– Removing CPUs from a defective system board (see section
"Swapping processors" on page 495)
Ê Remove the desired processor heat sink as described in section "Removing
processor heat sinks" on page 329.
11.3.3.1 Opening the cover plate
Figure 157: Opening socket release lever 1