RX300 S7
Upgrade and Maintenance Manual 523
Conversion configurations
15.3.7 Configuration 7 to configuration 8
Ê Replace multicage with the panelhousing and a HDD cage as described in
section "Replacing the front cages" on page 517.
Ê Connect cable C7 from connector X1 of the 4x 2.5-inch SAS backplane to
connector X3 of the 12x 2.5-inch SAS backplane
15.4 Concluding steps
Perform the following procedures to complete the task:
Ê "Installing the fan box" on page 184
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê Reconnect all external cables.
Ê "Connecting the server to the power source" on page 81
Ê "Closing the rack door" on page 84
Ê Update your server’s chassis information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 111.
Ê "Enabling BitLocker functionality" on page 107
To Next Page
Loading...
