426 Upgrade and Maintenance Manual
RX300 S7
Front panel
13.3 Front LAN connector
13.3.1 Installing the front LAN connector
13.3.1.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Installing the front LAN connector:
– Slotted screw driver for breaking out the front LAN cover plate
– Phillips PH2 / (+) No. 2 screw driver
13.3.1.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê "Removing the fan box" on page 183
Field Replaceable Units (FRU)
Average task duration: 10 minutes
To Next Page
Loading...
