Fujitsu PRIMERGY RX300 S7 - Preliminary Steps; Removing the UFM Board

RX300 S7 Upgrade and Maintenance Manual 461
System board and components
14.2.2.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
14.2.2.3 Removing the UFM board
Figure 289: Removing the UFM board (A)