RX300 S7
Upgrade and Maintenance Manual 203
Expansion cards and backup units
9.3 SAS RAID controller in PCI slot 7
9.3.1 Installing the SAS RAID controller
9.3.1.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Installing the SAS RAID controller:
– Phillips PH2 / (+) No. 2 screw driver
●
Mounting slot brackets:
– Phillips PH2 / (+) No. 2 screw driver
9.3.1.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Disabling SVOM boot watchdog functionality" on page 86
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Upgrade and Repair Units (URU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
