RX300 S7
Upgrade and Maintenance Manual 313
Processors
Ê "Enabling SVOM boot watchdog functionality" on page 101
Ê "Enabling BitLocker functionality" on page 107
11.4 Upgrading or replacing processors
V CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.4.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing and installing the processor heat sink:
– Phillips PH2 / (+) No. 2 screw driver
●
Upgrading or replacing the processor: tool-less
11.4.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Disabling SVOM boot watchdog functionality" on page 86
Ê "Locating the defective server" on page 56
Field Replaceable Units (FRU)
Average hardware task duration: 15 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
