RX300 S7
Upgrade and Maintenance Manual 37
Before you start
2.3 Tools you need at hand
When preparing the maintenance task, ensure that all required tools are
available according to the overview below. You will find a list of required tools at
the beginning of each procedure.
Screw driver /
Bit insert /
torque
Screw Usage Type
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
0.6 Nm
HDD cages
to chassis
RDX/DAT
cage in 3.5"
variant
(A100)
Slot bracket
to controller
board Slot
bracket to
chassis Fan
box
M3 x 4.5 mm
(silver)
C26192-Y10-C67
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
0.6 Nm
System
board
Front panel
M3 x 6 mm
(silver)
C26192-Y10-C68
To r x
TX10
0.6 Nm
3.5-inch HDD
UNC
6-32 x 4.76 mm
(silver)
C26192-Y10-C27
Phillips
PH0 / (+) No. 0
0.4 Nm
2.5-inch
HDD/SSDs
RDX/DAT in
2.5-inch
variant
M3 x 3.5 mm
Wafer head screw
(silver)
C26192-Y10-
C102
Table 2: List of required tools and used screws
To Next Page
Loading...
