RX300 S7
Upgrade and Maintenance Manual 287
Main memory
10.4 Replacing memory modules
10.4.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Replacing memory modules: tool-less
10.4.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Disabling SVOM boot watchdog functionality" on page 86
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65.
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs as described in section "Connectors and indicators on the system
board" on page 546.
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
Average software task duration: 5 minutes
To Next Page
Loading...
