490 Upgrade and Maintenance Manual
RX300 S7
System board and components
14.5.2 Preliminary steps
Perform the following procedures:
Ê Ensure to note down your current network settings in the operating system.
For further information, please refer to section "Note on network settings
recovery" on page 489.
Ê "Disabling BitLocker functionality" on page 85
Ê "Disabling SVOM boot watchdog functionality" on page 86
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê Disconnect all external cables.
Ê "Extending the server out of the rack" on page 69
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 70.
Ê "Removing the server cover" on page 72
Ê "Removing the air duct" on page 73
To Next Page
Loading...
