RX300 S7
Upgrade and Maintenance Manual 215
Expansion cards and backup units
9.4.1.3 Preparing the Modular LAN controller
Mounting the slot bracket
Figure 91: Mounting the PCI slot bracket
Ê Place the controller on the mounting tabs on the slot bracket.
Ê Carefully shift the slot bracket towards the controller until the plug shells
engage with the cut-outs in the slot bracket connector panel.
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws.
Connecting the NCSI sideband cable to the Modular LAN controller
I Connecting the NCSI sideband cable is only necessary in order to use
the Modular LAN controller as a shared LAN interface, that allows both,
management and dedicated LAN connections.
If the Modular LAN controller is to be used for dedicated network
connections only, please skip this section.
To Next Page
Loading...
