RX300 S7
Upgrade and Maintenance Manual 253
Expansion cards and backup units
Figure 120: Disconnecting the FBU adapter cable from the FBU
Ê Press down on the locking latch on the FBU cable and disconnect the FBU
adapter cable.
9.6.3.5 Installing a new FBU
Ê Install the new FBU into the FBU holder as described in section "Preparing
the FBU" on page 244.
Ê "Installing the FBU holder onto the air duct" on page 246
Ê Connect the FBU to the controller.
9.6.3.6 Concluding steps
Perform the following procedures:
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
To Next Page
Loading...
