RX300 S7
Upgrade and Maintenance Manual 331
Processors
11.5.5 Replacing processor heat sinks
11.5.5.1 Removing the processor heat sink
Ê Remove the processor heat sink as described in section "Removing
processor heat sinks" on page 329.
11.5.5.2 Applying thermal paste
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 332.
11.5.5.3 Installing the processor heat sink
Ê Install the processor heat sink as described in sections "Preparing the heat
sink and processor" on page 326 and "Installing the heat sink" on page 327.
11.5.6 Concluding steps
Perform the following procedures:
Ê "Installing the air duct" on page 74
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê "Connecting the server to the power source" on page 81
To Next Page
Loading...
