Fujitsu PRIMERGY RX300 S7 - Replacing the RDX;DAT Drive in 3.5-Inch Version; Required Tools; Preliminary Steps

RX300 S7 Upgrade and Maintenance Manual 369
Accessible drives
Ê "Closing the rack door" on page 84
Ê "Verifying and configuring the backup software solution" on page 98
Ê "Enabling BitLocker functionality" on page 107
12.10 Replacing the RDX/DAT drive in 3.5-inch
version
12.10.1 Required tools
● Preliminary and concluding steps: tool-less
● Replacing accessible drive:
– Phillips PH2 / (+) No. 2 screw driver
12.10.2 Preliminary steps
Perform the following procedures:
Ê "Disabling BitLocker functionality" on page 85
Ê "Opening the rack door" on page 64
Ê "Locating the defective server" on page 56
Ê "Removing backup and optical disk media" on page 89
Ê "Verifying and configuring the backup software solution" on page 89
Ê "Shutting down the server" on page 65
Ê "Disconnecting power cords" on page 66
Ê "Extending the server out of the rack" on page 69
Upgrade and Repair Units (URU)
Average task duration: 10 minutes