RX300 S7
Upgrade and Maintenance Manual 83
Basic hardware procedures
●
Follow the safety instructions in chapter "Important information" on
page 43.
Ê Connect all peripheral cables to the rear connector panel of the server.
Ê Connect and secure the power cords as described in section "Connecting
the server to the power source" on page 81.
Ê Connect all power cords to the power outlets.
I To provide true phase redundancy, the second power supply should
be connected to a different AC power source from the other supply. If
one AC power source should fail, the server will still continue to run.
Figure 24: Power button on the front panel
Ê Press the On / Off button to start up the server (1).
Ê Ensure that the power-on indicator above the On / Off button is lit green.
I For more information, refer to section "Front panel controls and
indicators" on page 555.
To Next Page
Loading...
