174 Upgrade and Maintenance Manual
RX300 S7
Hard disk drives / solid state drives
Figure 73: Connecting cables to the 12x 2.5-inch HDD SAS backplane
Ê Reconnect all cables to the 12x 2.5-inch HDD SAS backplane:
– Power cable (C4) connected to SAS backplane connector X15
– Power cable (C5) connected to SAS backplane connector X17
– SAS cable (C9) connected to SAS controller connector MLC1 to primary
backplane connectors X1
– SAS cable (C9) connected to SAS controller connector MLC2 to
secondary backplane connectors X2
I For a complete cabling overview, please refer to section "Cables
overview" on page 525.
To Next Page
Loading...
