RX300 S7
Upgrade and Maintenance Manual 195
Expansion cards and backup units
Ê "Mounting the server cover" on page 76
Ê "Sliding the server into the rack" on page 80
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 77.
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 81
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section "Updating RAID controller firmware" on page 96.
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 97.
Ê "Enabling SVOM boot watchdog functionality" on page 101
Ê "Enabling BitLocker functionality" on page 107
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 112.
Ê "Closing the rack door" on page 84
To Next Page
Loading...
