TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 147
Hard disk drives / solid state drives
7.2.4.3 Installing a 2.5-inch HDD / SSD dummy module
V CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 71: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.4.4 Concluding steps
Ê "Installing accessible drive and HDD bay covers" on page 71
To Next Page
Loading...
