TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 75
Basic hardware procedures
4.7 Switching on the server
V CAUTION!
●
Before switching on the server, make sure the top / side cover is
closed. In order to comply with applicable EMC regulations
(regulations on electromagnetic compatibility) and satisfy cooling
requirements, the PRIMERGY TX150 S8 / TX200 S7 server must not
run while the top / side cover is removed.
●
Follow the safety instructions in chapter "Important information" on
page 35.
Ê Press the On / Off button to start up the server.
Ê Ensure that the power-on indicator above the On / Off button is lit green.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
To Next Page
Loading...
