Fujitsu PRIMERGY TX150 S8 User Manual

TX150 S8 / TX200 S7 Upgrade and Maintenance Manual 67
Basic hardware procedures
4.5.2.3 Mounting the server in the rack
V CAUTION!
At least two people are needed to position the server on the rack rails.
(For the Japanese market, please refer to " 安全上のご注意 ".)
Additionally, a lifter is required in the following cases:
– The server weighs more than 50 kg.
– The server weighs more than 21 kg and is to be installed above the
height of 25 U.
When using a lifter, this installation procedure needs to be carried out by
maintenance personnel.
For configurations below 32 kg:
At least two people are needed to lift the server
into the rack cabinet.
For configurations below 55 kg:
At least three people are needed to lift the server
into the rack cabinet.
For configurations above 55 kg:
At least four people are needed to lift the server
into the rack cabinet.

Fujitsu PRIMERGY TX150 S8 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX150 S8
Category	Server
Language	English