Fujitsu PRIMERGY TX150 S8 - Concluding Steps; Replacing Memory Modules; Preliminary Steps

TX150 S8 / TX200 S7 Upgrade and Maintenance Manual 251
Main memory
Figure 171: Removing memory modules (B)
Ê Remove the ejected memory module.
10.3.3 Concluding steps
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Updating or recovering the system board BIOS and iRMC" on page 87 (if
applicable)
Ê "Switching on the server" on page 75
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling BitLocker functionality" on page 100
10.4 Replacing memory modules
10.4.1 Preliminary steps
Ê Identify the defective memory slot using the server management software.
Ê "Disabling or suspending BitLocker functionality" on page 79
Ê "Disabling SVOM boot watchdog functionality" on page 80
Ê "Locating the defective server" on page 47
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: tool-less