TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 271
11.5.4 Replacing processor heat sinks
11.5.4.1 Removing the processor heat sink
Ê Remove the processor heat sink as described in section "Removing
processor heat sinks" on page 270.
11.5.4.2 Applying thermal paste
Ê Apply thermal paste to the processor surface as described in section
"Applying thermal paste" on page 272.
I If the processor upgrade or replacement kit contains a new processor
heat sink, a thin layer of thermal compound has already been pre-
applied to its lower surface. In this case, please proceed with section
"Installing the processor heat sink" on page 271.
11.5.4.3 Installing the processor heat sink
Ê Install the processor heat sink as described in sections "Preparing the heat
sink and processor" on page 268 and "Installing the heat sink" on page 269.
11.5.5 Concluding steps
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Switching on the server" on page 75
To Next Page
Loading...
