EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S8 - Preliminary Steps; Removing the Defective TPM; Installing the New TPM; Concluding Steps

Fujitsu PRIMERGY TX150 S8
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
370 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7
System board and components
14.4.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 79
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê "Getting access to the component" on page 51
Ê "Removing the system fan holder" on page 76
14.4.3.2 Removing the defective TPM
Ê Remove the TPM as described in section "Removing the TPM" on page 365.
Ê Leave the TPM spacer on the system board when removing the defective
TPM.
14.4.3.3 Installing the new TPM
Ê The TPM spacer is already present on the system board (see "Installing the
TPM spacer" on page 363).
Ê Install the TPM as described in section "Installing the TPM" on page 361.
14.4.3.4 Concluding steps
Ê "Installing the system fan holder" on page 77
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Switching on the server" on page 75
Ê "Enabling BitLocker functionality" on page 100

Table of Contents

Other manuals for Fujitsu PRIMERGY TX150 S8

Related product manuals