346 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7
Front panel and external connectors
13.2.3 Replacing the front LAN connector and board
13.2.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 79
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê "Getting access to the component" on page 51
Ê "Removing the system fan holder" on page 76
13.2.3.2 Replacing the front LAN connector and board
Ê Remove the front panel module as described in section "Removing the front
panel module" on page 329.
Ê Remove the defective front LAN connector as described in section
"Removing the front LAN connector" on page 344.
Ê Install the new front LAN connector as described in section "Installing the
front LAN connector" on page 340.
Ê InstalI the front panel module cover on the front panel frame as described in
section "Installing the front panel module cover" on page 335.
Ê Install the front panel module as described in section "Installing the front
LAN connector" on page 340.
13.2.3.3 Concluding steps
Ê "Installing the system fan holder" on page 77
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General