EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S8 - Concluding Steps

Fujitsu PRIMERGY TX150 S8
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 339
Front panel and external connectors
Figure 258: Connecting the front LAN board to the system board
Ê If applicable, connect the front LAN board to the system board (1).
Ê If applicable, run the front LAN cable through the cable guide (2).
13.1.1.5 Concluding steps
Ê "Installing the system fan holder" on page 77
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Switching on the server" on page 75
Ê "Verifying system information backup / restore" on page 89
Ê Store your server’s system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 103.
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling BitLocker functionality" on page 100

Table of Contents

Other manuals for Fujitsu PRIMERGY TX150 S8

Related product manuals