EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S8 - Removing the Defective Memory Module; Installing the New Memory Module; Concluding Steps

Fujitsu PRIMERGY TX150 S8
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
252 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7
Main memory
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê "Getting access to the component" on page 51
Ê Locate the defective memory module using the onboard Local Diagnostic
LEDs as described in section "Onboard indicators and controls" on
page 421.
10.4.2 Removing the defective memory module
Ê Remove the memory module as described in section "Removing a memory
module" on page 250.
10.4.3 Installing the new memory module
Ê Install the memory module as described in section "Installing a memory
module" on page 249.
10.4.4 Concluding steps
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Updating or recovering the system board BIOS and iRMC" on page 87 (if
applicable)
Ê "Switching on the server" on page 75
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling replaced components in the system BIOS" on page 95
Ê "Verifying the memory mode" on page 96
Ê "Enabling BitLocker functionality" on page 100

Table of Contents

Other manuals for Fujitsu PRIMERGY TX150 S8

Related product manuals