Fujitsu PRIMERGY TX150 S8 - Removing a 2.5-Inch HDD; SSD Module; Installing a 2.5-Inch HDD; SSD Module; Concluding Steps; Replacing a 2.5-Inch HDD SAS Backplane

TX150 S8 / TX200 S7 Upgrade and Maintenance Manual 149
Hard disk drives / solid state drives
7.2.5.2 Removing a 2.5-inch HDD / SSD module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section "Removing a 2.5-inch HDD / SSD module" on page 146.
7.2.5.3 Installing a 2.5-inch HDD / SSD module
Ê Install the new HDD / SSD module into the empty drive bay as described in
section "Installing 2.5-inch HDD / SSD modules" on page 142.
7.2.5.4 Concluding steps
Ê "Installing accessible drive and HDD bay covers" on page 71
Ê "Performing a RAID array rebuild" on page 101
7.2.6 Replacing a 2.5-inch HDD SAS backplane
7.2.6.1 Preliminary steps
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê "Getting access to the component" on page 51
Ê "Removing the system fan holder" on page 76
Ê "Removing 2.5-inch HDD / SSD modules" on page 145
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver