EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S8 - Converting a Tower Model to a Rack Model; Preliminary Steps

Fujitsu PRIMERGY TX150 S8
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 389
15 Converting a tower model to a
rack model
Safety notes
For further information, please refer to chapter "Important information" on
page 35.
15.1 Preliminary steps
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê Remove all external cables.
Ê "Getting access to the component" on page 51 including "Removing the
front cover" on page 61
I The front cover is no longer required.
Ê "Removing the anti-tilt bracket" on page 77
Upgrade and Repair Unit
(URU)
Hardware: 20 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Slotted screw driver

Table of Contents

Other manuals for Fujitsu PRIMERGY TX150 S8

Related product manuals