266 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7
Ê Remove the desired processor as described in section "Removing a
processor" on page 260.
Ê Install the new processor as described in section "Installing a processor" on
page 255.
Ê In case of transferring a processor install the protective cover to the
defective system board as described in section "Installing the protective
cover" on page 263.
11.4.3 Concluding steps
Ê "Installing processor heat sinks" on page 268
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
I If Global Error LED is flashing with error message CPU has been
changed on display after the system is powered on, please follow the
procedure below.
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the LED stops flashing. This is only information regarding
to the change of CPU configuration. There is no technical problem.
Ê "Updating or recovering the system board BIOS and iRMC" on page 87 (if
applicable)
Ê "Switching on the server" on page 75
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling BitLocker functionality" on page 100
To Next Page
Loading...
Need help?
General