EasyManua.ls Logo

Fujitsu PRIMERGY TX150 S8 - Concluding Steps; Software Configuration

Fujitsu PRIMERGY TX150 S8
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 355
System board and components
Figure 268: Installing the UFM
Ê Connect the UFM to the system board (1), snapping in the UFM spacer.
Ê Fasten the nylon screw (2).
14.3.1.3 Concluding steps
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Switching on the server" on page 75
Ê "Enabling SVOM boot watchdog functionality" on page 94
Ê "Enabling BitLocker functionality" on page 100
14.3.1.4 Software configuration
The UFM delivery set includes the "Recovery Tool CD" to setup the ESXi
configuration. Proceed as follows:
Ê Switch on the server.
Ê Right after switching on the server, insert the "Recovery Tool CD" into the
DVD drive and close the drive tray.
Ê The server should now boot from the "Recovery Tool CD".
Ê Follow the on-screen instructions.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX150 S8

Related product manuals