TX150 S8 / TX200 S7
Upgrade and Maintenance Manual 285
Accessible drives and LSD
– For full performance, connect the USB 3.0 RDX drive to a USB 3.0
PCI interface card by USB 3.0 cable.
– The USB 3.0 cable cannot be connected to a USB 2.0 RDX drive.
12.2.5 Concluding steps
Ê "Installing the system fan holder" on page 77
Ê "Reassembling" on page 64
Ê "Connecting the server to the mains" on page 74
Ê "Switching on the server" on page 75
Ê If applicable, "Verifying and configuring the backup software solution" on
page 92
12.3 Removing accessible drives
12.3.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Removing backup and optical disk media" on page 82
Ê "Verifying and configuring the backup software solution" on page 83
Ê "Shutting down the server" on page 50
Ê "Disconnecting the server from the mains" on page 50
Ê "Getting access to the component" on page 51
I The front cover only needs to be removed in order to remove or install
accessible drive dummy covers.
Ê "Removing the system fan holder" on page 76
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General